Size Estimation Chart (transparency)
Developed from and based on the TAPPI Dirt Estimation Chart, this transparency is used to measure the size of spots, defects, or inclusions over the range of 0.02 to 5.00 square millimeters in paper and other industrial materials such as textiles or plastics. Instructions for use of this transparency are outlined in TAPPI Test Method T 564. The chart can be used in a large number of applications where there is a need to estimate a size (area) by way of a direct comparison to a known area disk or rectangle. Applications may include, but are not limited to, the measurement of visible ink spatter on printed surfaces, the estimation of the growth rate of bio-colonies, air inclusions in transparent plastic castings and films, etc. The chart must NOT be used to estimate the equivalent black area (EBA) of dirt or other colored specks (use the TAPPI Dirt Estimation Chart in conjunction with T 213 or T 437 or use image analysis, T 563, for EBA measurement). The charts are manufactured from an original negative produced on DuPont CRR film. A rapid-access processor using Kodak/Fujifilm chemistry is used for processing the transparencies. Each film positive is produced on Kodak Contact 2000 film, using a NuArc contacting frame with an NuArc light source and NuArc light integrator which controls the exposure. The cards are exposed to 20 units of light. To measure the accuracy of the end product, each transparency is measured by looking at the 2.0 dot with a 100-power magnifier that has a reticle (scale), incremented in 5/10,000’s of a millimeter, on the lens. The dots on the chart are correct within an average 10% or 0.005 square millimeters, whichever is the larger.
You may also be interested in TAPPI’s dirt estimation charts. TAPPI’s Dirt Chart cards are manufactured from an original negative produced on DuPont CRR film and estimate the equivalent black area (EBA) of dirt or other colored specks in conjunction with T 213 or T 437 or use image analysis, T 563, for EBA measurement.
Product code: 0109DIRTT
You may also like ...
- Approved by the Standard-Specific Interest Group for this method TAPPI Folding endurance of paper (Schopper type tester), Test Method T 423 cm-07
- CIE whiteness and tint of paper and paperboard (d/0 geometry, C/2 illuminant /observer), Test Method T 560 om-05
- Color of paper and paperboard (d/0, C/2), Test Method T 527 om-07
- Fiber analysis of paper and paperboard, Test Method T 401 om-08
- Zero-span breaking strength of pulp (dry zero-span tensile), Test Method T 231 cm-07
- A Comparison of Metering Elements for Producing Double-Coated Paperboard, 2004 Coating and Graphic Arts Conference
- A Multiphase Mechanism for Setting and Gloss Development of Offset Ink, 2006 TAPPI Advanced Coating Fundamentals Symposium
- A New Analytical Model for Impact and Spreading of One Drop Application to Inkjet Printing, 2006 TAPPI Advanced Coating Fundamentals Symposium
- A Novel Talc Pigment for Paper Coatings, 2005 TAPPI Coating Conference
- A Re-Evaluation of Factors Controlling Print Rub on Matt and Silk Coated Papers, 2006 Coating & Graphic Arts Conference


