Search
Use the search bar or filters below to find any TAPPI product or publication.
Filters
Content Type
Publications
Level of Knowledge
Committees
Collections
Journal articles
Deinking flexographic newsprint: using ultrafiltration to close the water loop, TAPPI JOURNAL, February 1997, Vol. 80(2)
Deinking flexographic newsprint: using ultrafiltration to close the water loop, TAPPI JOURNAL, February 1997, Vol. 80(2)
Journal articles
The basics of Agenda 2020, TAPPI JOURNAL, February 1997, Vol. 80(2)
The basics of agenda 2020, TAPPI JOURNAL, February 1997, Vol. 80(2)
Journal articles
2020 vision - focusing on the future, TAPPI JOURNAL, February 1997, Vol. 80(2)
2020 vision - focusing on the future, TAPPI JOURNAL, February 1997, Vol. 80(2)
Journal articles
Maximizing performance of electrostatic precipitators, TAPPI JOURNAL, February 1997, Vol. 80(2)
Maximizing performance of electrostatic precipitators, TAPPI JOURNAL, February 1997, Vol. 80(2)
Journal articles
Outsourcing providers, TAPPI JOURNAL, February 1997, Vol. 80(2)
Outsourcing providers, TAPPI JOURNAL, February 1997, Vol. 80(2)
Journal articles
System control, monitoring and piping considerations for automated grease system, TAPPI JOURNAL, February 1997, Vol. 80(2)
System control, monitoring and piping considerations for automated grease system, TAPPI JOURNAL, February 1997, Vol. 80(2)
Journal articles
Pulping and papermaking properties of managed second-growth softwoods, TAPPI JOURNAL, January 1997, Vol. 80(1)
Pulping and papermaking properties of managed second-growth softwoods, TAPPI JOURNAL, January 1997, Vol. 80(1)
Journal articles
Canadian industry: 1996 review, TAPPI JOURNAL, January 1997, Vol. 80(1)
Canadian industry: 1996 review, TAPPI JOURNAL, January 1997, Vol. 80(1)
Journal articles
The association angle: CPPA on Canada, TAPPI JOURNAL, January 1997, Vol. 80(1)
The association angle: cppa on canada, TAPPI JOURNAL, January 1997, Vol. 80(1)
Journal articles
Magazine articles
Investigation of the influencing factors in odor emission from wet-end white water, TAPPI Journal October 2020
ABSTRACT: Emission of malodorous gases, such as volatile organic compounds (VOCs), hydrogen sulfide (H2S), and ammonia (NH3) during pulping and papermaking has caused certain harm to the air environment and human health. This paper investigated the influencing factors of odor emission from wet-end white water during the production of bobbin paper in a papermaking mill using old corrugated containers (OCC) as raw material. The concentration of malodorous gases emitted from wet-end white water was determined with pump-suction gas detectors. The results indicated that low temperature could limit the release of malodorous gases from white water. Specifically, no total volatile organic compounds (TVOC), H2S, and NH3 was detected at a temperature of 15°C. The concentrations of malodorous gases were slightly increased when temperature increased to 25°C. When temperature was 55°C, the released concentrations of TVOC, H2S, and NH3 were 22.3 mg/m3, 5.91 mg/m3, and 2.78 mg/m3, respectively. Therefore, the content of malodorous gases significantly increased with the temperature increase. The stirring of white water accelerated the release of malodorous gases, and the release rate sped up as the stirring speed increased. However, the total amount of malodorous gases released were basically the same as the static state. Furthermore, the higher the concentration of white water, the greater the amount of malodorous gases released. The pH had little influence on the TVOC release, whereas it significantly affected the release of H2S and NH3. With the increase of pH value, the released amount of H2S and NH3 gradually decreased. When pH reached 9.0, the release amount of H2S and NH3 was almost zero, proving that an alkaline condition inhibits the release of H2S and NH3.