Search

Use the search bar or filters below to find any TAPPI product or publication.

Showing 151–160 of 1,848 results (Duration : 0.009 seconds)

Filters

Industry

Topics

Content Type

Publications

Level of Knowledge

Committees

Collections

Journal articles
Open Access
Optimizing Water Resistance of Linerboard coatings Using

Optimizing Water Resistance of Linerboard coatings Using Pigments

Journal articles
Open Access
A Simple Method for Calculation of the Permeability

A Simple Method for Calculation of the Permeability Coefficient of Porous Media

Journal articles
Open Access
Upsets in papermaking ash control: various dead-time compens

Upsets in papermaking ash control: various dead-time compensators, TAPPI JOURNAL, October 2006

Journal articles
Open Access
Electrochemical Removal of Color and Toxicity from Bleached

Electrochemical Removal of Color and Toxicity from Bleached Kraft Effluents, 1994 Environmental Conference Proceedings

Journal articles
Open Access
Qualification of Welding Procedures for Duplex Stainless Ste

Qualification of Welding Procedures for Duplex Stainless Steels, 1999 Engineering Conference Proceedings

Journal articles
Open Access
Lignin Recovery from Kraft Black Liquor: Preliminary Process

Lignin Recovery from Kraft Black Liquor: Preliminary Process Design, 1990 Pulping Conference Proceedings

Journal articles
Magazine articles
Open Access
Preparation of regenerated cellulose from rice straw lignocellulosic waste and its use for reinforced paper products, TAPPI Journal July 2021

ABSTRACT: Rice straw waste is a lignocellulosic waste produced by farmers in large quantities. In this study, regenerated cellulose (RC) from rice straw was prepared by dissolving rice straw holocellulose (HC) in NaOH/Urea/Thio-urea/Water solution by the freeze-thawing process. The crystallinity index of RC was calculated at 31%, which is out of the crystallinity range of 39%•69% that has been previously suggested.The study indicated that the RC is amorphous with a low degree of polymerization (638) and higher hydroxyl group content as compared to HC. The fiber length of RC was found to be 26.7% shorter; however, the width of RC was 21.2% higher as compared to HC. Reduced kinked fiber content was observed in the fraction of RC (18.3%) as compared with HC (39.1%), and a higher curl index of fiber was observed more so in HC (10.5%) than RC (5.6%). Because of the regeneration process, the fiber length was reduced and a fines element content of about 96% was observed in RC compared to the initial fines content of HC (56.9%). Irrespective of the high fines element content of RC, the composite paper of rice straw bleached pulp and RC fibers was developed with an increase in the tensile index from 41.4 N.m/g to 71.2 N.m/g and an increase in the burst index from 4.7 kPa.m2/g to 5.3 kPa.m2/g with the addition of 5% and 15% RC, respectively. However, enhanced tear index of paper was observed up to 5% and then it declined upon further addition of RC. The study revealed that regenerated cellulose can be used as a strength additive to overcome the shortcomings of low mechanical properties in paper products.

Journal articles
Open Access
Chip size distribution for an ultra-high-yield sulfite process

Over the Wire, Paper360º November/December 2014

Journal articles
Open Access
TAPPI survey of 1987 incomes, TAPPI JOURNAL August 1988

TAPPI survey of 1987 incomes, TAPPI JOURNAL August 1988

Journal articles
Open Access
Pressurized grinding of chemically treated wood, TAPPI JOURNAL January 1988 88JAN117

Pressurized grinding of chemically treated wood, TAPPI JOURNAL January 1988

Inside this Section