Search
Use the search bar or filters below to find any TAPPI product or publication.
Filters
Content Type
Publications
Level of Knowledge
Committees
Collections
Journal articles
Magazine articles
Lignin value prior to pulping (LVPP): An advanced pulping c
Lignin value prior to pulping (LVPP): An advanced pulping concept, TAPPI JOURNAL October 2017
Journal articles
Magazine articles
Degradation of 2,4-dichlorophenol by melamine amine cellulos
Degradation of 2,4-dichlorophenol by melamine amine cellulose- immobilized lacasses, TAPPI JOURNAL October 2017
Journal articles
Magazine articles
How to use total dissolved solids measurements to evaluate the performance of diffuser washers—A mill study, TAPPI Journal April 2020
ABSTRACT: Various types of pulp washing equipment are available. Each washing device has a unique mechanical construction, and the washing principle is often a combination of dilution, thickening, and displacement washing. In this work, the performance of the pressure diffuser washer is studied. In stepwise trials, the effect of the feed and discharge consistencies on the performance of the diffuser was studied. The effect of the downward velocity of the screen on the pressure diffuser’s washing efficiency was also studied. The measurement of total dissolved solids (TDS) by a process refractometer was used as a wash loss measurement unit and the refractometer’s results were used in the calculations of standardized Nordén efficiency (E10) values. The chemical oxygen demand (COD) and conductivity values were also measured and their results compared to the TDS results.The results indicated that feed consistency has a significant effect on the performance and effectiveness of the diffuser washers in the mill. It can also be stated that when the downward velocity of the screen is adjusted to too high a level, the washing efficiency of the pressure diffuser decreases. As a conclusion from the mill tests, it can be stated that even small process parameter changes can provide enhanced diffuser washing at the beginning of the washing line, which has a direct effect on the performance of post-oxygen washing.
Journal articles
Magazine articles
Mill experience of calcium carbonate scale formation in green liquor pipelines, TAPPI Journal August 2020
ABSTRACT: Experience of hard calcite (CaCO3) scale formation in green liquor pipelines at four kraft pulp mills was systematically investigated to determine if there is any correlation between the severity of the scaling problem at each mill and the design and operating conditions of its causticizing plant. The results show that the high degree of supersaturation of calcium ions (Ca2+) in the liquor is the main contributing factor. Mills that operate at a lower green liquor total titratable alkali (TTA), higher causticity, and a larger liquor temperature drop are more likely to produce a green liquor that is supersaturated with Ca2+, and thus experience more severe scaling problems. In order to minimize CaCO3 scaling, the green liquor handling equipment should be operated as steady as possible to avoid conditions that allow Ca2+ to be supersaturated. The strategies include minimizing variations in liquor TTA, insulating the green liquor pipelines to reduce temperature gradients, and adding lime mud to weak wash to provide seeds for precipitation to occur on mud particles instead of on metal substrate.
Journal articles
Magazine articles
Combustion behavior of kraft black liquor droplets from hot
Combustion behavior of kraft black liquor droplets from hot water pretreated hardwood and softwood chips, November 2016 TAPPI JOURNAL
Journal articles
Medium Consistency Oxygen Delignification Performed with a Controlled Cavitation Reactor, TAPPI JOURNAL, February 2006, Vol. 5(2) (376 KB)
Medium Consistency Oxygen Delignification Performed with a Controlled Cavitation Reactor, TAPPI JOURNAL, February 2006, Vol. 5(2) (376 KB)
Journal articles
A Low-Temperature, Black Liquor Gasifier Model for Use in WinGEMS, TAPPI JOURNAL, February 2006, Vol. 5(2) (242 KB)
A Low-Temperature, Black Liquor Gasifier Model for Use in WinGEMS, TAPPI JOURNAL, February 2006, Vol. 5(2) (242 KB)
Journal articles
Polarized light reflectometry for studies of paper coating s
Polarized light reflectometry for studies of paper coating structure - Part I. Method and instrumentation, TAPPI JOURNAL, July 2006, Vol. 5(7)
Journal articles
Mineral Scale Management - Part II. Fundamental Chemistry, T
Mineral Scale Management - Part II. Fundamental Chemistry, TAPPI JOURNAL, July 2006, Vol. 5(7)
Journal articles
Mineral Scale Management, Part I. Case Studies, TAPPI JOURNA
Mineral Scale Management, Part I. Case Studies, TAPPI JOURNAL, June 2006, Vol. 5(6) (192 KB)