Search
Use the search bar or filters below to find any TAPPI product or publication.
Filters
Content Type
Publications
Level of Knowledge
Committees
Collections
Journal articles
Magazine articles
Investigation of the influencing factors in odor emission from wet-end white water, TAPPI Journal October 2020
ABSTRACT: Emission of malodorous gases, such as volatile organic compounds (VOCs), hydrogen sulfide (H2S), and ammonia (NH3) during pulping and papermaking has caused certain harm to the air environment and human health. This paper investigated the influencing factors of odor emission from wet-end white water during the production of bobbin paper in a papermaking mill using old corrugated containers (OCC) as raw material. The concentration of malodorous gases emitted from wet-end white water was determined with pump-suction gas detectors. The results indicated that low temperature could limit the release of malodorous gases from white water. Specifically, no total volatile organic compounds (TVOC), H2S, and NH3 was detected at a temperature of 15°C. The concentrations of malodorous gases were slightly increased when temperature increased to 25°C. When temperature was 55°C, the released concentrations of TVOC, H2S, and NH3 were 22.3 mg/m3, 5.91 mg/m3, and 2.78 mg/m3, respectively. Therefore, the content of malodorous gases significantly increased with the temperature increase. The stirring of white water accelerated the release of malodorous gases, and the release rate sped up as the stirring speed increased. However, the total amount of malodorous gases released were basically the same as the static state. Furthermore, the higher the concentration of white water, the greater the amount of malodorous gases released. The pH had little influence on the TVOC release, whereas it significantly affected the release of H2S and NH3. With the increase of pH value, the released amount of H2S and NH3 gradually decreased. When pH reached 9.0, the release amount of H2S and NH3 was almost zero, proving that an alkaline condition inhibits the release of H2S and NH3.
Journal articles
Infrared analysis for process control in the pulp and paper industry, TAPPI JOURNAL, October 2000, Vol. 83(10)
Infrared analysis for process control in the pulp and paper industry, TAPPI JOURNAL, October 2000, Vol. 83(10)
Journal articles
Dispersion of pulp slurries using carboxymethylcellulose, TAPPI JOURNAL, October 2000, Vol. 83(10)
Dispersion of pulp slurries using carboxymethylcellulose, TAPPI JOURNAL, October 2000, Vol. 83(10)
Journal articles
Application of polyallylamine as a dry strength agent for paper, TAPPI JOURNAL, December 2000, Vol. 83(12)
Application of polyallylamine as a dry strength agent for paper, TAPPI JOURNAL, December 2000, Vol. 83(12)
Journal articles
Abitibi consolidated's mill in snowflake, az, converts to 100% recycling, TAPPI JOURNAL, April 2000, Vol. 83(4)
Abitibi consolidated's mill in snowflake, az, converts to 100% recycling, TAPPI JOURNAL, April 2000, Vol. 83(4)
Journal articles
Tear and tensile properties of soda pulps from kenaf bast fibers, TAPPI JOURNAL, June 2000, Vol. 83(6)
Tear and tensile properties of soda pulps from kenaf bast fibers, TAPPI JOURNAL, June 2000, Vol. 83(6)
Journal articles
Water minimization in the washing section of a paperboard mill, TAPPI JOURNAL, September 2000, Vol. 83(9)
Water minimization in the washing section of a paperboard mill, TAPPI JOURNAL, September 2000, Vol. 83(9)
Journal articles
Design and operation of a woodwaste cogeneration plant, TAPPI JOURNAL, September 2000, Vol. 83(9)
Design and operation of a woodwaste cogeneration plant, TAPPI JOURNAL, September 2000, Vol. 83(9)
Journal articles
Electrical distribution systems benefit from new circuit breaker technology, TAPPI JOURNAL, January 2000, Vol. 83(1)
Electrical distribution systems benefit from new circuit breaker technology, TAPPI JOURNAL, January 2000, Vol. 83(1)
Journal articles
A Kids' View of 'Forests For Our Future', TAPPI JOURNAL, January 2000, Vol. 83(1)
A Kids' View of 'Forests For Our Future', TAPPI JOURNAL, January 2000, Vol. 83(1)